poe-fault - light the led when PoE out budget is close to the maximum supported limit.modem-technology - turns on leds in order of modem technology generation: GSM 3G LTE single led turns on only when LTE is active.modem-signal - blink the led on 3G modem signal (either USB or miniPCIe).interface-transmit - blink the led on interface transmitted traffic.interface-status - light the led on interface status change.interface-speed-25G - light the led when interface works in 25Gbit rate.interface-speed-1G - light the led when interface works in 1Gbit rate.interface-speed - light the led when interface works in 10Gbit rate.interface-receive - blink the led on interface received traffic.interface-activity - blink the led on interface (traffic) activity.
flash-access - blink the led on flash access.fan-fault - light the led when any of the device controlled fans stop working.ap-cap - blink on CAP initializing with CAPsMAN, steady on once connected.align-up - light the led if the w60g device needs to be aligned upwards.align-right - light the led if the w60g device needs to be aligned to the right.align-left - light the led if the w60g device needs to be aligned to the left.align-down - light the led if the w60g device needs to be aligned downwards for the best signal quality.Type ( align-down | align-left | align-right | align-up | ap-cap | fan-fault | flash-access | interface-activity | interface-receive | interface-speed | interface-speed-1G | interface-speed-25G | interface-status | interface-transmit | modem-signal | modem-technology | off | on | poe-fault | poe-out | wireless-signal-strength | wireless-status Default: ) For example wireless signal strength will require more than one led. List of led names used for status report. Modem-signal-treshold ( integer Default: ) Applicable only if type is interface specific. Name of the interface which will be used for led status. RB Groove uses five leds for wireless strength and one for ethernet activity monitoring. It is possible to configure the leds to display wireless strength, blink the leds on interface traffic activity and many other options.įor example default led configuration on /system leds> print RouterOS allows to configure each leds activity the way that user wishes.
0 kommentar(er)
